To Next PageTo Next PageWhy is my Daewoo DWD-HB143 making a thumping sound?
A thumping sound in your Daewoo Washer might be normal if you're washing a heavy load. However, if the sound continues, it could mean the washer is out of balance. Stop the washer and redistribute the wash load.
What to do if my Daewoo Washer won't start?
If your Daewoo Washer isn't starting, ensure the power cord is securely plugged into the wall. Also, check your house fuse or circuit breaker and reset it if necessary. Finally, make sure the water supply tap is turned on.
Why is my Daewoo DWD-HB143 making a vibrating noise?
Ensure all transit bolts and packing have been removed from your Daewoo Washer. If not, refer to the installation guide. Also, check that all the feet are resting firmly on the ground. An unevenly distributed wash load can also cause vibration, so stop the washer and rearrange the load.
Why is my Daewoo DWD-HB143 Washer leaking water?
If your Daewoo Washer is leaking, check if the inlet or drain hoses are loose at the tap or washer and tighten them. Also, the house drain pipes might be clogged; unclog them or contact a plumber if needed.
What to do if water in my Daewoo Washer does not drain or drains slowly?
If water isn't draining properly from your Daewoo Washer, check the drain hose for kinks or clogs and clean or straighten it. Also, clean the drain filter.
How to fix LE DOOR OPEN ERROR on Daewoo DWD-HB143 Washer?
To resolve an LE DOOR OPEN ERROR on your Daewoo Washer: - Close the door if the Start/Pause button was pressed while it was open. - Change the switch door lock. - Change the PCB ASS?Y.
How to fix OE DRAIN ERROR on Daewoo DWD-HB143?
To address an OE DRAIN ERROR on your Daewoo Washer: - Clean and straighten the drain hose. - Change the drain motor. - Change the valve inlet. - Change the water level sensor. - Change the PCB ASS?Y.
How to fix UE UNBALANCE ERROR on Daewoo Washer?
If your Daewoo Washer displays a UE UNBALANCE ERROR, it means the laundry is concentrated on one side of the drum during the spin cycle. To fix this, simply rearrange the laundry inside the drum.
How to fix IE WATER INLET ERROR on Daewoo Washer?
To fix an IE WATER INLET ERROR on your Daewoo Washer: - Open the water tap. - Clean the filter of the valve inlet. - Change the valve inlet. - Change the water level sensor (sensor pressure). - Change the drain motor. - Change the PCB ASS?Y.
What to do if my Daewoo Washer door does not open?
If the door of your Daewoo Washer won't open, wait two minutes after the wash cycle has ended. This allows the electric locking mechanism time to release for safety reasons.
General
