R
Richard DanielSep 9, 2025
What to do when my Daewoo DWD-F1233 Washer shows H6 HEATER WASH ERROR?
- MMeagan Everett DDSSep 9, 2025
To resolve the H6 HEATER WASH ERROR on your Daewoo Washer, you should change the heater wash.
To Next PageTo Next PageWhat to do when my Daewoo DWD-F1233 Washer shows H6 HEATER WASH ERROR?
To resolve the H6 HEATER WASH ERROR on your Daewoo Washer, you should change the heater wash.
What to do if the Daewoo DWD-F1233 door does not open?
If your Daewoo Washer door won't open, wait two minutes to allow the electric locking mechanism to release after the cycle has stopped. The door is designed to remain locked for safety reasons once a cycle has started.
What to do if my Daewoo DWD-F1233 Washer won't start?
If your Daewoo washer isn't starting, ensure the power cord is securely plugged into the wall outlet. Check your house fuse or circuit breaker, and reset it if necessary. Also, verify that the water supply tap is turned on.
How to fix a Daewoo Washer that won't spin?
If your Daewoo washer won't spin, make sure the door is firmly shut. Close the door and press the Start/Pause button. After pressing the Start/Pause button, it may take a few moments before the clothes washer begins to spin. The door must lock before spin can be achieved.
What to do if my Daewoo Washer leaks water?
If your Daewoo Washer is leaking water, check and tighten the inlet and drain hose connections at both the tap and the washer itself. Additionally, inspect your house drain pipes for clogs and unclog them. If the problem persists, it may be necessary to contact a plumber.
How to troubleshoot E6 EMG ERROR on Daewoo Washer?
To resolve the E6 EMG ERROR on your Daewoo Washer, rearrange the laundry to ensure it is not jammed between the gasket and the drum. If problems persist you should change the motor or the PCB ASS’Y.
How to resolve LE DOOR OPEN ERROR on Daewoo Washer?
To resolve the LE DOOR OPEN ERROR on your Daewoo Washer, ensure the door is closed properly. This error can occur if the Start/Hold button is pressed while the door is open. If problems persist you should change the switch door lock or the PCB ASS’Y.
What to do when my Daewoo DWD-F1233 Washer shows E2 OVERFLOW ERROR?
To fix the E2 OVERFLOW ERROR on your Daewoo Washer, you should change the valve inlet, water level sensor or drain motor.
How to fix a Daewoo DWD-F1233 when the water drains slowly?
If the water in your Daewoo washer isn't draining properly or drains slowly, check the drain hose for kinks or clogs and clean and straighten it. Also, inspect the drain filter for clogs and clean it.
How to fix H5 WATER TEMP. ERROR on Daewoo DWD-F1233?
To resolve the H5 WATER TEMP. ERROR on your Daewoo Washer, you should change the thermistor wash.
General| Loading Type | Front Load |
|---|---|
| Spin Speed | 1200 rpm |
| Color | White |
| Programs | 15 |
| Delay Start | Yes |
| Child Lock | Yes |
| Quick Wash | Yes |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
Diagrams and specifications for various DWD-F1X series washing machines.
Instructions for removing transit bolts and preparing the installation site.
How to clean the exterior, interior, and detergent case of the washing machine.
Step-by-step instructions for disassembling key components like the door lock and heater.
Diagram of the control panel for DWD-F1X1X series models.
Detailed breakdown of washing, rinsing, and spinning stages for different programs.
Procedures for testing the washing machine's operation and components.
Lists common issues like noise, leaks, and slow draining with their causes.
Diagram showing electrical connections to the main PCB and various components.
