THE REPAIR METHOD
19
No. Process Notice
Assemble 1
1
2
3
4
Assemble the coupling
Assemble the new clutch boss
ass’y
Assemble the pulley
Assemble the spring washer
Check the uneven face of
coupling is assembled upward.
- Push in the clutch boss ass’y
with rotating on the clockwise
direction.
-
After assembling, rotate on
the clockwise more 2~3 teeth
and pull out the pulley shaft
upward.
If there was plain washer, you
have to assemble plain washer
the first and then assemble
spring washer.
THE PROCESS OF ASSEMBLE
To Next Page
Loading...
