10
• Press this button to turn the power 'ON' or 'OFF'.
• It can be used to choose water temperature to be suppliued.
• As the button is pressed, water temperature will be repeated.
COLD → COLD+HOT → HOT
• In case of the single valve model, there is no wash temperature
selector function.
• It can be used to adjust amount of water according to the size of the
load to be washed.
• As the button is pressed, water level is selected by
MID → HIGH → LOW
• It is the button for the partial process or the combination of each
process ( wash, rinse, spin ) ( See page 10 )
• If you want to change wash time, rinse time, spin time , you must press
this button after selecing each process by the process button.
Also, this button can be used to spin only. ( See page 10 )
• It can be used to select the full-automatic program.
• As the button is prassed, program will be selected by following order:
FUZZY → QUICK → DELICATE → HEAVY → TUB CLEAN
• Operation and temporary stop is repeated as it is pressed.
• When you want change program in operating;
press the "START/PAUSE" button → select the program that you want
to change → press the "START/PAUSE" button again.
THE FUNCTIONS OF THE CONTROL PANEL
DWF-ELC55BGN,DWF-ELC55GPN(영)_호주향.indd 10 16. 7. 8. 오후 12:08
To Next Page
Loading...
