5.11 - External Parts Cleaning
Keeping the external parts clean can prevent debris build-up and ensure easy
access during maintenance.
Do not use a pressure washer to clean this product. Delicate electrical
components may be damaged.
1. Place unit in a well-lit area
2.
areas around the gas tank and oil ports.
3. Use a soft, damp cloth to clean off remaining residue and debris.
4. Allow unit to dry before using it.
6.0 - TROUBLESHOOTING
following these instructions, contact technical support before attempting to use or repair the product.
ISSUE CAUSE ACTION
Engine will not
start
Faulty spark plug
Use a wrench to remove the spark
plug and follow procedure for
cleaning or replacing
Clogged fuel line
Check fuel line for leaks. Unclog if
necessary
Wrong fuel type
with appropriate fuel
Carburator not getting air or fuel Take to service dealer
Starter not functioning Take to service dealer
Power is low
Throttle lever unadjusted
Slide throttle lever to increase
power output
Water output
is low
Clogged strainer Remove debris and rinse with water
Suction hose blocked with debris Remove obstruction
Damaged hoses Replace hoses
Clogged impeller Remove obstruction
Lose hose clamps Tighten or replace hose clamps
Leaking seals Take to service dealer
No water
output
Incorrect pump placement
Reposition pump (see placement
section of manual)
Pump is not primed Prime pump
Pump mechanism is damaged Take to service dealer
18
English
To Next Page
Loading...
