Service Remote Controller
-12-
Key Content Default Value Description
SSC Enable OFF Spread Spectrum ON/OFF
SSC Delta 0 Don't Care
SSC posi 0 Don't Care
SSC nega 0 Don't Care
BBE Level 48 BBE Level
MVOICE Level 96 MVOICE Level
Sound Delay(ms) 40 Sound Delay
S10 MISC EDID Update OFF EDID Update
Model SL-230A DLA-32C7 Chassis
S/W Version SL-230A_L######V#D Decoder S/W Version
Micom Version SL-230D_M######V##M PIC Micom S/W Version
Micom Update OFF Micom Update Mode
OS_DbgPrintf OFF Debugging Mode
Digital Signal Status OFF Digital Signal Status
Digital Index Status OFF Don't Care
RF Software Update OFF RF S/W Update Mode
S1 HeatRun Enable OFF HeatRun Enable Mode
Panel Model S/S Don't Care
Digital Index level 133 Don't Care
LG Tuner Enable ON Don't Care
Index PCA9557 Enable
ON Smart Icon
S11 Pattern Test Pattern 0 Don't Care
S12 Reset Factory Reset 0 Factory Reset
Eeprom Reset 0 EEPROM Reset
▶ Hot Key Operation
[S1] key works Heat Run mode.
Heat-run mode is enable only when 'S1 Heat Enable' is on in MISC.
[S2] key works channel & EDID update mode. It is necessary only DTV Factory in Gumi.
[S7] key works channel update mode in DEMDA.
[S12] key works Factory Reset mode in directly.
※ [S10] -> [Menu] -> [S12 Reset] -> [Eeprom Reset] : EEPROM has default value.
▶ [S5] -> [PQ] -> [Brightness & Contrast] : This data can be changed only in each mode.
: For example, [Main DTV Cont] value can be
changed only in DTV mode.
To Next Page
Loading...
