Daewoo RN-331N - 4. How To Change Door Position; 4.1. Tilt Down Appliance; 4.2. Disassemble Parts; 4.3. Move Door Accessories

Features are model dependent ( Below is RN-271 model )
4. How To Change Door Position
1-2> Disassemble following parts in order.
- 'Top Cover Hinge' and 'Top Hinge'(a)
-'Refrigerator Door'(b)
- 'Middle Hinge'(c)
- 'Middle Cover Hinge'(d)
- 'Freezer Door'(e)
- 'Under Hinge'(f)
- 'Adjusting Leg '(g)
1-1> Tilt down the appliance to the rear.
(Watch out for "Pipe Wire Condensor" damage.)
a
b
c
d
e
f
g
Refrigerator
Door
1-3> Move following 'Door Accessories' in the
opposite position:
- 'Cover Bushings'(i)
- 'Door Stoppers'(j)
1-4> Change the position of following parts each
other and assemble them:
'Adjusting Leg '(g) & 'Under Hinge'(f)
1-5> Level and assemble the 'Freezer Door'(e)
1-7>
Level and assemble the 'Refrigerator Door'(b).
1-6> Change the position of following parts each
other and assemble them:
'Middle Cover Hinge'(d) & 'Middle Hinge'(c)
1-8>
Assemble following parts on the opposite side:
'Top Cover Hinge' and 'Top Hinge'(a)
j
i
Freezer
Door
23