EasyManua.ls Logo

DAHON UNIO E20 - Battery Management and Warranty; Charger and Battery Protection; Battery Maintenance and Storage; Terms of Warranty

DAHON UNIO E20
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Charger & Battery Protection
Battery Maintenance
Storage Recommendations
Terms of Warranty
The battery and charger unit have a built-in heat sensor. If the heat
rises too much, it will automatically shut down the system before any
damage can occur. The charger unit will automatically cut off the power
supply after 12 hours of charging.
Have you recharged your battery pack lately?
If 3 months have passed without recharging, it’s time to do it again.
Charging your battery will help ensure maximum battery life and
performance and will help to avoid battery damage.
The Dahon Unio E20 warranty period is 2 Years (24 months) according
to the date of purchase.
For all electrical parts including charger, display (console), controller,
BB sensor, electrical cables, carrier and motor, (Note: motor noise is
not covered) the warranty period is 2 Years (24 months).
Batteries must be charged prior to use. Do not incinerate or mutilate
batteries. They may explode or release toxic material. Do not disassemble
the battery. Return the bike to your authorized service dealer for service
or repair.
Store the battery in a cool dry place. Please refer to your dealer regarding
transport of the battery.
Cycle (charge and discharge) the battery every 3-6 months to maintain
battery performance when being stored for an extended period of time.
In the case of any irregular noise, variant temperature, Or leakage from
the battery, please stop using it immediately.
Always store and cool the battery in a well-ventilated place, out of direct
sunlight.
NOTE:
Always remember to press the battery switch to turn
off the power before parking your Unio or taking out
the batterry.
12

Related product manuals