Dahua Technology HFW5241E-ZE - Network Configuration; Initializing Device

Quick Start Guide
4
2 Network Configuration
Device initialization and IP setting can be finished with the "ConfigTool" or in web interface. For more
information, see the Web Operation Manual.
 Device initialization is available on select models, and it is required at first use and after device is
being reset.
 Device initialization is available only when the IP addresses of the device (192.168.1.108 by
default) and the PC stays in the same network segment.
 Planning useable network segment properly to connect the device to the network.
 The following figures and interfaces are for reference only, and the actual product shall prevail.
Initializing Device 2.1
Double-click "ConfigTool.exe" to open the tool. Step 1
Click . Step 2
The Modify IP interface is displayed. See Figure 2-1.
Modify IP interface Figure 2-1
Click Search setting. Step 3
The Setting interface is displayed.
Enter the start IP and end IP of the network segment in which you want to search devices, Step 4
and then click OK.
All the devices found in the network segment are listed.
Select one or several devices which Status are Uninitialized, and then click Initialize. Step 5