Quick Start Guide
4
Next.
Step 4 Select
Auto-check for updates as needed, and then click OK to initialize the device.
If initialization failed, click to see more information.
Step 5 Click
Finish.
2.2 Changing the Device IP Address
●
You can change the IP address of one or more devices at a time. This section is based on
changing IP addresses in batches.
●
Changing IP addresses in batches is available only when the corresponding devices have the
same login password.
Step 1 Search for the device whose IP address needs to be changed through ConfigTool.
1. Double-click ConfigTool.exe to open the tool.
2. Click
Modify IP.
3. Select the searching way, enter the username and password, and then click OK.
The username is admin, and the password is the one you set while initializing the
device.
Step 2 Select the devices whose IP addresses need to be changed, and then click Modify IP.
Step 3 Configure IP address.
●
Static mode: When you select Static, you need to enter Start IP, Subnet Mask, and
Gateway. The IP addresses of the devices will be modified successively starting from
the first IP entered.
●
DHCP mode: If the DHCP server is available in the network, when you select DHCP, the
IP address of devices will be automatically obtained through the DHCP server.
The same IP address will be set for multiple devices if you select the Same IP checkbox.
Step 4 Click
OK.
2.3 Logging in to Web Page
Step 1 Open IE browser, enter the IP address of the device in the address bar, and then press the
Enter key.
If the setup wizard is displayed, finish the settings as instructed.
Step 2 Enter the username and password in the login box, and then click
Login.
Step 3 For the first-time login, click Click Here to Download Plugin, and then install the plugin as
instructed.
The home page is displayed when the installation is finished.
To Next Page
Loading...
Need help?
General
