8
5 NVR Setup
5.1 Making Connections
1. Determine where you will install your system.
2. Ensure the input voltage matches the rated power requirements for the device. Ensure the power
supply delivers a stable current. It is recommended to use a UPS to ensure a stable current.
3. Connect a VGA or HDMI cable to the rear panel and to the display.
4. Connect the mouse to the USB port on the rear panel.
5. Connect a network cable to the NVR and to a router or a modem.
6. Connect the power cable to your system and surge protector. The NVR enters the boot mode
after power is applied and the NVR defaults to the multiple-window video mode.
5.2 Logging In
The NVR has four built-in accounts:
Note: For security reason, modify the password after the initial login.
Click Enter or left mouse click to access the System Login interface. Type a default Username and
Password to access the system.
Figure 5-1
Note:
• Three login failures within 30 minutes causes the system to issue an alarm.
• Five login failures within 30 minutes causes the system to lock the account.
To Next Page
Loading...
Need help?
General