HDCVI Standalone DVR User’s Manual
Figure 4-29
4.5.3.4 Call PTZ Function
Call Preset
In Figure 4-24, input preset value and then click to call a preset. Click
again to stop call.
Call Pattern
In Figure 4-24, input pattern value and then click to call a pattern. Click
again to stop call.
Call Tour
In Figure 4-24, input tour value and then click to call a tour. Click again
to stop call.
Call Scan
In Figure 4-24, input Scan value and then click to call a tour. Click again
to stop call.
Rotate
In Figure 4-24, click to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
Preset, tour and pattern all need the value to be the control parameters. You can
define it as you require.
You need to refer to your camera user’s manual for Aux definition. In some cases, it
can be used for special process.
To Next Page
Loading...
