HDCVI Standalone DVR User’s Manual
the video brightness if the value is high. But the video
noise may become too clear.
It is to enhance video effect.
It includes several modes such as standard, color,
bright, gentle. Select a color mode, the sharpness,
brightness, contrast and etc can automatically
switch to corresponding setup.
Customized: It is to set four color modes. Check all
to set video sharpness, hue, brightness, contrast.
Click OK to complete the customized setup.
Click reset button, you can restore saturation value to
the default setup.
Image position (For
analog channel only)
It is to adjust the image position on the screen. The
number here refers to the pixel. The default pixel is 16.
Click it to set customized setup.
4.5.6 Search
Please refer to chapter 4.9.1 for detailed information.
4.5.7 Manual Record
Please refer to chapter 4.11.4.3.1 for detailed information.
4.5.8 Alarm Output
Please refer to chapter 4.11.3.4 for detailed information.
4.5.9 Remote Device
Please note it is for digital channel only.
Please refer to chapter 4.11.1.1 for detailed information.
4.5.10 Video Matrix
Please refer to chapter 4.11.5.3 for detailed information.
4.5.11 Main menu
Please refer to chapter 4.8 for detailed information.
4.6 Navigation Bar
You need to go to the Main menu->Setting->System->General to enable navigation
bar function; otherwise you can not see the following interface.
The navigation bar is shown as below. See Figure 4-32.
To Next Page
Loading...
