HDCVI Standalone DVR User’s Manual
Figure 4-77
4.11.1.3.5 Channel Type
This function is for some series only. Some series products support analog
standard definition connections/analog HD connection/network camera
connection while some series products support analog HD connection/network
camera connection only.
For HDCVI signal and analog standard definition signal, system can auto
recognize channel type, there is no need to set or restart. For analog channels,
the interface here is to display channel type only. You can change cable mode
(Coaxial/UTP) if you are using HDCVI.
For analog channel, if there is no video connection, it only displays the
previous connection record. It can auto display current connection type after
you connect the camera.
It is to set channel type. Each channel supports analog camera（analog standard
definition/HDCVI） /network camera connection. Please note DVR needs to restart to
activate new setup. The network camera connection shall begin with the last channel. For
the 16-channel (or higher) series product, please click to go to the next page to set.
See Figure 4-78.
To Next Page
Loading...
