Installation and Configuration Manual
12
Wall mount
2.2.2.4 Ceiling Mount
Procedure
Step 1 Drill holes on the ceiling according to the holes on the junction box.
Step 2 Use 3 ST6.3 expansion screws to fix the junction box to the ceiling.
Step 3 Tighten the screws on the end of the camera to fix it to the junction box.
Ceiling mount
2.2.3 Installing Anti-smashing Radars
In the vertical direction of the lane, install the anti-smashing radar on the box below the automatic
barrier arm.
To Next Page
Loading...
