Installation and Configuration Manual
33
You can configure up to 4 rules.
Step 6 Click Save.
Configuring Remote Control of Barrier Gate
4.2.1 Configuring Remote Control of DHI-IPMECD-203X Barrier Gate
Paring codes for remote control:
On the motherboard, press and hold SET and then press + to enter the programming mode.
When F1 is displayed on the nixie tube of the motherboard, press and hold the SET for 6 s, and
then the advanced menu C0 is displayed. Press SET several times until the C7 is displayed on
the nixie tube.
Press + to enter C7 parameter configuration page, and the stored number of remote control
codes is displayed on the nixie tube.
Press + to start the remote control learning. Press and hold on the matching remote
control until the indicator of barrier gate board flashes, and the number increases by 1,
indicating that the remote control learning is successful.
If other remote controls need to pair codes, repeat step 4.
After the remote control learning is completed, exit the learning mode on the motherboard.
Press SET to return to the function status C7, and then press and hold SET and the press – to
exit the programming mode.
Clearing codes for remote control:
On step 3, the nixie tube displays the number of remote control codes that have been stored.
Press – three times to clear all the learned remote controls of the barrier gate.
To Next Page
Loading...
Need help?
General
