Dahua DSS4004-S2 Application Deployment Manual

Config System 7
Parameter
Note
Link
By binding Ethernet and external communication, now
bound Ethernet port take part in work to share network
loading. It achieves one Network card forwarding higher
than 1K stream. For example, 2 IP are bound, and other two
are multiple address. So this server can have 3 IP, bound IP
with bandwidth of 2K. the other two is 1K; for scene of pure
forwarding stream (not recommend to store).
Network card
When network mode setup is fault-tolerant, balance load or link,
you shall set binding of Network card.
Click “Add Bind Card”，select Network card you want to bind,
and set two bound cards.
Default
Network card
Select default Network card, this card will be default port
forwarding to non-adjacent segments (i.e. WAN) data pack.
Select
Network card
Select Network card or bind card, you can see this Network card
or binding card info below.
MAC Address
Show platform server MAC address.
IP Address
After you select Network card, you can set IP address, subnet
mask, default gateway, preferred DNS server address and
alternate DNS server address of this Network card.
Subnet Mask
Default
Gateway
Preferred DNS
Alternate DNS
Click Save and Reboot to save config and reboot server.

Dahua DSS4004-S2 Specifications

General

Brand	Dahua
Model	DSS4004-S2
Category	Server
Language	English