10
2 HDD Installation
You can install six 10T HDDs (hard disk drives).
To avoid insufficient storage space, HDDs larger than 2T are recommended.
To reduce the writing pressure of each HDD, we recommend you to install at least 2 HDDs with
the same capacity for data collection and recharging.
Loosen the screws on the rear cover, and then remove the rear cover. Step 1
Remove rear cover Figure 2-1
Disconnect the cables between main board and HDD plate. Step 2
Loosen cable Figure 2-2
Loosen the four fixed screws on the HDD box, and then take out the box. Step 3
To Next Page
Loading...