Dahua IPC-C26E - LED Indicator Status Meanings

2
Note:
 Use the pry bar included in the packaging to open the top panel to access the Reset/WPS
Button and the SD Card slot.
 Press the Reset/WPS button to enable WPS.
 Press the Reset/WPS button for 10 seconds to reset the device to the factory settings.
LED Indicators
LED Indicator Light
Device Status
Off

Powered off.
 Rebooting after reset.
Steady Red
Device malfunction. Try resetting the camera (see ‘Camera
Overview’ for details) and repeating the setup.
Flashing Red
Network connection failed. Try resetting the camera (see
‘Camera Overview’ for details) and repeating the setup.
Flashing Green Waiting for network connection.
Steady Green Operating normally.
Alternating Flashing Red/Green Firmware updating.