Dahua NVR41-P Series User Manual

360
or the phone you set to get alarm message.
Check send SMS box and then input the phone number in the receiver column. Click to add one
receiver. Repeat the above steps you can add more phones. Select a phone number and then click ,
you can delete it. Click OK button to complete the setup.
Figure 5-38
5.10.2.6 PPPoE
The PPPoE interface is shown as in Figure 5-39.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from the
IP address column.
Please note, you need to use previous IP address in the LAN to login the device. Please go to the
IP address item to via the device current device information. You can access the client-end via
this new address.

Dahua NVR41-P Series Specifications

General

Brand	Dahua
Model	NVR41-P Series
Category	Network Hardware
Language	English