Dahua PFH610V-IR - Install Camera; Operating Control Instruction

10
2.3 Install Camera
Step 1 Take camera installation plate out of the housing.
Step 2 Fix the camera onto camera installation plate.
Step 3 Fix camera installation plate onto housing shell, as shown in Figure 2-8.
 During installation of camera lens, try to get close to inner surface of glass (1-3mm away from
the inner surface), so as not to affect viewing angle of the lens.
 According to camera size, camera installation plate can be installed at obverse side and
reverse side.
Figure 2-8
No.
Component Name
1
Camera
2
Screws to fix camera installation plate (M3×8 combination
screws)
3
Camera installation plate
4
Screws to fix camera (1/4-20×8UNC pan head combination
screw)
Table 2-4
2.4 Operating Control Instruction
IR lamp panel owns dial switch; 6 IR lamps are turned on by default. Except remote mode 1, in the