12
3 Installation Guide of Bracket
3.1 Install General Bracket
Protective housing can be installed with a bracket, which owns general threaded holes. Threaded
holes (M6) of general bracket on protective housing are shown in Figure 3-1.
Figure 3-1
3.2 Install Special Bracket
Special bracket means integration of housing and bracket, and thus supports concealed wiring.
Step 1 Wiring harness goes through the bracket, as shown in Figure 3-2.
Step 2 Fasten the bracket onto protective housing, as shown in Figure 3-3.
Step 3 Put a waterproof joint onto wiring harness, and tighten the waterproof joint, as shown in
Figure 3-4.
Figure 3-2
To Next Page
Loading...