Daikin 4MXL-T Series

SiUS121827E SA Indoor Unit Functions
Part 4 Functions and Control 99
3. Auto-off by sensor (with presence sensor)
After pre-determined time has elapsed without detection of human presence, the unit automatically
stops operation.
The auto-off time can be set between 1- 24 hours by the hour.
Once the unit stops operation by auto-off function, the system would not restart even if the human
is detected again.
 Auto-off by sensor is enabled only when decoration panel BYFQ60C2W1W(S), sensor kit
BRYQ60A2W(S) and wired remote controller BRC1E73 are connected to the main unit and
auto-off by sensor is set to “enabled” on the wired remote controller.
 Factory setting is “disabled”.
Setting on the remote controller
R4003391
2
3
4
1
Press buttons to select
Auto-off by Sensor .
Press Menu/OK button to display
Auto-off by Sensor menu.
Press buttons to select Enable .
Press buttons to go into the auto-off
time setting.
Press buttons to set auto-off hour(s)
(1 ~ 24).
Press Menu/OK button. Then the
confirmation screen is displayed.
Press Cancel button for 4 seconds on
the basic screen to display Service
Settings menu.
Press buttons to select Energy
Saving Options .
Press Menu/OK button to display
Energy Saving Options menu.
Setting
1/3
Service Settings
Test Operation
Maintenance Contact
Field Settings
Energy Saving Options
Prohibit Function
Min Setpoints Differential
Setting
Energy Saving Options
Setpoint Range Limitation
Auto-setback by Sensor
Auto-off by Sensor
5
Setting
Auto-off by Sensor
Enable/Disable: Enable
Auto-off in: 24 hr(s)
Setting
Auto-off by Sensor
Enable/Disable: Enable
Auto-off in: 24 hr(s)
Setting
Save the settings?
Auto-off by Sensor
Ye s No
Press buttons to select Yes .
Press Menu/OK button to confirm the
settings and to return to the Service
Settings menu.