Daikin Altherma EHVH/X11+16S18CB - To Remove the Accessories from the Outdoor Unit; Indoor Unit; To Unpack the Indoor Unit; About the Units and Options

4 About the units and options
Installer reference guide
8
ERHQ+ERLQ011~016 + EHVH/X11+16S18+26CB
Daikin Altherma – Low temperature split
4P384975-1C – 2018.02
3.2.3 To remove the accessories from the
outdoor unit
1×
2
1
a
1×
c
1×
b
2×
d
1×
e
1×
f
1×
g
1×
a Outdoor unit installation manual
b Cable tie
c Fluorinated greenhouse gases label
d Multilingual fluorinated greenhouse gases label
e Screw (only for ERLQ)
f Thermistor fixing plate (spare) (only for ERLQ)
g Thermistor fixture (only for ERLQ)
3.3 Indoor unit
3.3.1 To unpack the indoor unit
3.3.2 To remove the accessories from the
indoor unit
1 Remove the screws at the top of the unit.
2 Remove the top panel.
3 Remove the screws at the front of the unit.
4 Push on the button on the bottom of the front plate.
5 Remove the front plate.
WARNING: Sharp edges
Take the front plate on the upper part instead of the lower
part. Watch your fingers, there are sharp edges on the
lower part of the front plate.
a~e+h
g
f
5
4
1
2
3
4
4×
2×
6 Remove the accessories.
1×
1× 1× 1× 1×
2× 1×2×
a b c d
f ge
h
a General safety precautions
b Addendum book for optional equipment
c Indoor unit installation manual
d Operation manual
e Sealing ring for shut-off valve
f Shut-off valve
g User interface cover
h 2 screws for fixing the user interface.
7 Reinstall the top panel and the front plate.
4 About the units and options
4.1 Overview: About the units and
options
This chapter contains information about:
▪ Identifying the outdoor unit
▪ Identifying the indoor unit
▪ Combining outdoor and indoor units
▪ Combining the outdoor unit with options
▪ Combining the indoor unit with options