Daikin ALTHERMA - Status Icons; Basic Usage

EVLQ05+08CAV3
Daikin Altherma hybrid heat pump – outdoor unit
4P344906-1 – 2013.02
Installation manual
3
3Installation
3.2.2 To prepare drain work
Make sure that condensation water can be evacuated properly.
An additional drain pan kit (EKDP008CA) can be used to gather the
drain water. The drain pan kit consists of:
3.2.3 To install the outdoor unit
1 Lift the outdoor unit as described in To remove the accessories
from the outdoor unit.
2 Install the outdoor unit as follows:
3 Remove the protective cardboard and instruction sheet.
NOTICE
If the drain holes of the outdoor unit are blocked up, provide
space of at least 300 mm below the outdoor unit.
a Drain pan
b U-beams
a
b
CAUTION
Do NOT remove the protective cardboard before the unit is
installed properly.
a Air outlet
NOTICE
The pedestal MUST be aligned with the backside of the
U-beam.
a Protective cardboard
b Instruction sheet
283 mm
580 mm
2x
2
aa
1
b
a
4PEN344906-1_2013_02.book Page 3 Tuesday, July 16, 2013 8:15 AM