Daikin BRC1D61 - Programming the First Day of the Week

Programming
1
THE
SCHEDULE
TIMER
IS
PROGRAMMED
FOR
THE
FIRST
TIME
NOTE
| =
When changing day during programming
you will have to confirm "the last action".
Each day can have 5 programmed
actions (numbered 1 to 5) but for some
feason you might want to delete one,
several or all programmed actions,
To be able to delete programmed actions,
you must select the last action that you
want to keep, this can be 1 to 5 or no
action (© is displayed and no action
displayed).
All programmed actions with a number
HIGHER than the selected one, or all
programmed actions if no last action was
selected will be deleted.
PROGRAMMING THE FIRST DAY OF THE WEEK
NOTE
€-
In the guidelines below it is assumed that
you start programming the schedule
timer actions on Monday and end with the
schedule timer actions for Sunday.
If you prefer NOT to start on Monday, first
browse to the desired day and then enter
the PROGRAM mode.
In
this
particular
case,
no
actions
have
been
program-
med
before,
all
schedule
timer
actions
are
idle.
Browse
to
Monday
by
pressing
the
®
button.
The
©
icon
appears,
MN
will
blink
and
one
of
the
ee
[4]
(Al
icons
might
be
displayed
but
all
other
fields
remain
blank,
indicating
that
no
actions
are
programmed
for
Monday.
Enter
the
program
mode
by
holding
down
the
#t>
button
for
5
seconds,
the
©
icon
will
now
blink
too.
Press the © button to activate the first
programmed action.
Ablinking
1
is
displayed
indicating
that
the
first
programmed
action
for
Monday
is
being
programmed;
The
set
temperature
and
clock
display
are
blinking.
Press the ® tea] button to select either set
temperature, OFF, or limit operation.
Enter the desired temperature using the
C2 & @CZD buttons.
Press the me button to toggle between
minimum set temperature and maximum set
temperature in limit operation, the selected
temperature will blink.
Enter the time when the action must start
using the OCA) & OCZ) buttons (min.
step = 10 minutes).
NOTE If, by accident, you pressed the <>
e- button, you activated the next action; { 9
is displayed (1 steady and 2 blinking).
Press the >) button repeatedly until a
blinking 1 {8 displayed, You can now
continue adjusting the settings for the first
schedule timer action.
Operation manual
11
DAIKIN
BRC1D61
Remote controller
3P107422-30