Daikin BRC1D61 - Deleting Schedule Timer Programs; Controller Maintenance; Maintenance; Controller Cleaning

3 {WANT TO DELETE ONE OR MORE
PROGRAMMED ACTIONS
Make sure you are not in program mode (© not
blinking); if required, press asx to quit program
mode.
Browse to the programmed actions using the co)
button, select the day you want to edit.
Press the cS) button for 5 seconds; program mode is
enabled, the @ icon and selected action are blinking.
Select the “last action" you want to keep using the
} button. All higher actions will be deleted.
Confirm the deletion by pressing the > button for 5
seconds,
OR
confirm the deletion for > current and the next day
too by pressing the #> and buttons
simultaneously for 5 seconds. ® B
NOTE In the case above, if for example the last
wae action was 3, the programmed actions 4
Lay and 5 will also be deleted (if they were
present).
4 | WANT TO DELETE ALL PROGRAMMED
ACTIONS AT ONCE
Quit programming or browsing.
Press the > and &, buttons simultaneously for 5
seconds; the © icon will invert and disappear to
confirm deletion.
7. Maintenance
The remote controller does not need maintenance.
Remove dirt with a soft damp ctoth.
aaa Sg rer arin Ss
NOTE Only use clear tapid water to moisten the
cloth.
8, Troubleshooting
The guidelines below might help to solve your
problem. If you cannot remedy the problem, consult
your installer.
No readings on the remote controller (display
blank)
Check if the mains power is still applied to your
installation.
Only &§ is displayed
This indicates that the installation has just been
powered, please wait until G@ disappears.
The schedule timer does work but the
programmed actions are executed at the wrong
time (e.g. 1 hour too fate or too early)
Check if the clock and the day of the week are set
correctly, correct if necessary (refer to "CLOCK
SETTING FUNCTION" on page 4).
I cannot enable the schedule timer (the © icon
blinks for 2 seconds and disappears)
The schedule timer has not been programmed yet.
First program the schedule timer (refer to
“Programming the schedule timer” on page 10).
{ cannot enable the schedule timer (the ate
icon is displayed)
The schedule timer can not be enabled when a
centralised control is connected.
Limit operation cannot be selected
Limit operation is not available for cooling only
installations,
Operation
manual
DAIKIN
BRC1D61
13
Remote controller
3P107422-3D