9 English
• The SECOND CODE number is factory set to “01”.
Do not use any settings not listed in the table.
For group control with a wireless remote controller, initial settings for all the indoor units of the group are
equal. (For group control, refer to the installation manual attached to the indoor unit for group control.)
6. TEST OPERATION
• Perform test operation according to the instructions in the installation manual attached to the outdoor unit.
[PRECAUTIONS]
1. Refer to the installation manual attached to the outdoor unit for individual operation system types.
12 (VRV
system)
1
ON/OFF input from outside
(Set to enable starting/stopping
from remote.)
Forced OFF input ON/OFF –
2
Thermostat differential changeover
(Set when using remote controller
thermostat sensor.)
1°C 0.5°C –
13 0
Air flow rate increase mode (to be
set upon user’s request)
Standard A little increase Increase
3(1%ERRN3DJH:HGQHVGD\-DQXDU\30
To Next Page
Loading...
