6
Types of receiving tone
The following receiving tones sound when
remote controller signals are detected by the
receiver.
2 SHORT BEEPS:
Signal from the remote controller was
received successfully.
1 LONG BEEP:
(Error tone) The selected function is not
supported on this indoor unit.
3 SHORT BEEPS:
(Error tone) Setting/change cannot be made
using this remote controller as centralised
control is in operation.
NOTE
• After settings are changed or operation is
turned ON/OFF, make sure that the
receiving tone of the indoor unit makes
a beeping sound.
The maximum transmitting distance
is 7 to 9 m.
This depends on the installation condition
of the indoor unit.
Do not drop or get it wet.
It may be damaged.
Never press the button of the remote
controller with a hard, pointed object.
The remote controller may be damaged.
Installation site
• It is possible that signals will not be
received in room that have electronic
fluorescent lighting.
Please consult with your local dealer
before buying new fluorescent lights.
• If the remote controller operated some
other electrical apparatus, move that
machine away or consult your local dealer.
• Do not install the remote controller in
places exposed to direct sunlight. Doing
so could result in discolouration and failure
of the LCD.
Loading the batteries
Position and
correctly!
+
–
2
3
1
Placing the remote controller in the
remote controller holder.
Be sure to install the remote controller holder.
Remote
controller holder
Placing the
remote controller
Put it inside Pull it upward
Wireless
remote controller
1. Slide the front cover
and remove it.
2. Put 2 dry cell
batteries AAA.
3. Replace the front
cover.
Removing the
remote controller
2 short beeps
from the receiver
indicates that the
transmission is
properly done.
To Next Page
Loading...
