7
Refer to figure 1 on page [1]
• Operating procedure varies with heat
pump type and cooling only type. Contact
your Daikin dealer to confirm your system
type.
• To protect the unit, turn on the main power
switch 6 hours before operation.
7. OPERATION PROCEDURE
Operate in the following order.
〈〈
FOR SYSTEMS WITHOUT COOL/
HEAT CHANGEOVER REMOTE
CONTROL SWITCH
〉〉
Refer to figure 1-1, 2 on page [1]
OPERATION MODE
SELECTOR
Press OPERATION MODE SELECTOR
button several times and select the
OPERATION MODE of your choice as
follows.
COOLING OPERATION ................... “ ”
The recommended set temperature is
26 to 28°C.
HEATING OPERATION .................... “ ”
The recommended set temperature is
18 to 23°C.
AUTOMATIC OPERATION ............... “ ”
COOLING, HEATING, AUTOMATIC,
FAN, AND PROGRAM DRY
OPERATION
When to change batteries
Under normal use, batteries last about a
year. However, change them whenever the
indoor unit doesn’t respond or responds
slowly to commands, or if the display
becomes dark.
[CAUTIONS]
• Replace all batteries at the same time, do
not use new and old batteries intermixed.
• In case the remote controller is not used
for a long time take out all batteries in order
to prevent liquid leak of the battery.
IN THE CASE OF CENTRALIZED
CONTROL SYSTEM
If the indoor unit is under centralized control,
it is necessary to switch the remote
controller’s setting.
In this case, contact your DAIKIN dealer.
Refer to operation manual attached to the
indoor unit.
5. OPERATION RANGE
6. INSTALLATION SITE
If the temperature or the humidity is beyond
the operation range*, safety devices may
work and the air conditioner may not
operate, or sometimes, water may drop from
the indoor unit.
*Refer to the operation range shown in the
operation manual attached to the indoor or
outdoor unit.
• Do not shut off the power supply during
seasonal use of the air conditioner.
This is required in order to activate the
air conditioner smoothly.
• If the main power supply is turned off
during operation, operation will restart
automatically after the power turns back
on again.
• Operation modes supported depend on
the model that is connected.
• For cooling only type, “COOLING”, and
“FAN” and “PROGRAM DRY” operation
are able to select.
1
• In this operation mode, COOL/HEAT
changeover is automatically conducted.
• AUTOMATIC OPERATION controls the
temperature based on the set
temperature, so it maintains a
comfortable temperature throughout the
year.
To Next Page
Loading...
