19
7
Reset of the display
Press the OPERATION MODE
SELECTOR button to get the display
back to the normal state.
[Trouble]
The OPERATING INDICATOR LAMP of the
indoor unit is flashing and the unit does not
work at all.
(Refer to page 5, 6)
Malfunction
Code
INSPECTION display
Unit No.
which
sensed
trouble
[Remedial action]
Check the malfunction code on the remote
controller and contact your local dealer.
(Refer to page 17)
1
Press the INSPECTION button to
select the inspection mode “ ”.
The initial set value
Press the button 2 times to
return to normal operation mode.
13. HOW TO CHECK THE
INITIAL SET VALUE
Further question regarding to the available
functions, contact your local dealer with your
initial setting value confirmed by using the
remote controller with the following steps.
To Next Page
Loading...
