EasyManuals Logo

Daikin DM96VC User Manual

Daikin DM96VC
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
37
and their corresponding taps. Verify CFM by noting the
number displayed on the dual 7-segment LED display.
6. The multi-speed circulator blower also offers several custom
ON/OFF ramping profiles. These profiles may be used to
enhance cooling performance and increase comfort level.
The ramping profiles are selected using DIP switches S4-
1, 2. Refer to the following figure for switch positions
and their corresponding taps. Refer to the following bullet
points for a description of each ramping profile. Verify
CFM by noting the number displayed on the dual 7-segment
LED display.
34
AOFFOFF
B* ON OFF
COFFON
DONON
(Indicates factory setting)
Sw itch Bank S4
Heating
Airflow
DIP Sw itc h No.
Profile A provides only an OFF delay of one (1) minute
at 100% of the cooling demand airflow
.
OFF
100% CFM 100% CFM
1 min
OFF
Figure 50
Profile B ramps up to full cooling demand airflow by
first stepping up to 50% of the full demand for 30
seconds. The motor then ramps to 100% of the
required airflow. A one (1) minute OFF delay at 100%
of the cooling airflow is provided.
50% CFM
1/2 min
100% CFM
100% CFM
1 min
OFF
OFF
Figure 51
Profile C ramps up to 85% of the full cooling demand
airflow and operates there for approximately 7 1/2
minutes. The motor then steps up to the full demand
airflow. Profile C also has a one (1) minute 100%
OFF delay.
100% CFM
OFF
OFF
Figure 52
NOTE: To enable adjustments and select -5, 5, -10 or 10% trim,
you must set dip switch S5-2 to ON. If S5-2 is in the OFF position,
you will receive 0% trim.
12
AOFFOFF
BONOFF
COFFON
D* ON ON
Sw itch Bank : S3
Cooling Speed
Taps
DIP Sw itc h No.
(*Indicates factory setting)
34
+ 5%* OFF OFF
- 5% ON OFF
+ 10% OFF ON
- 10% ON ON
Sw itch Bank : S3
Adjust Taps
DIP Sw itc h No.
(*Indicates factory setting)
Profile D ramps up to 50% of the demand for 1/2 minute,
then ramps to 85% of the full cooling demand airflow
and operates there for approximately 7 1/2 minutes.
The motor then steps up to the full demand airflow.
Profile D has a 1/2 minute at 50% airflow OFF delay.
OFF
OFF
Figure 53

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Daikin DM96VC and is the answer not in the manual?

Daikin DM96VC Specifications

General IconGeneral
BrandDaikin
ModelDM96VC
CategoryFurnace
LanguageEnglish

Related product manuals