Installation manual
4
EKFCMBCB7
Modbus interface PCB kit
4PW65443-1B – 2021.06
INSTALLATION METHOD IN COMBINATION WITH FWF MODELS
The installation box KRP1BA101 is needed.
Mount the installation box and PCB as explained in the installation manual of the KRP1BA101 kit.
See figure 3
1 KRP1BA101 Box with Modbus PCB
2 Communication wiring (to field)
3 Wiring to fan coil unit PCB
4 Wire X7A-F1/F2
5 Wire X1A-X35A
6 Tie wrap
7 Hook (supplied with KRP1BA101 kit)
INSTALLATION METHOD IN COMBINATION WITH FWC MODELS
The installation box KRP1H98 is needed.
Install the installation box and PCB in the unit as explained in the installation manual of the KRP1H98
kit. The PCB needs to be mounted on the bottom of the box (see KRP2A52).
See figure 4
1 KRP1H98 with Modbus PCB
2 Communication wire from field
3 Wire X7A-F1/F2
4 Wire X1A-X38A
5 Tie wrap
6 Room for excess cable
4PWEN65443-1B.book Page 4 Tuesday, June 29, 2021 11:58 AM
To Next Page
Loading...
