Daikin EWAT_B - 4.12 Controller IP Setup

EWAT_B
Operating Manual
23/38
4.12 Controller IP Setup
The Controller IP Setup page is located at the path Main Menu  View/Set Unit  Controller IP Setup.
All of the information about current MTIII IP Network settings is reported in this page, as shown in the following table:
Parameter
Range
Description
DHCP
On
The DHCP option is enabled.
Off
The DHCP option is disabled.
IP
xxx.xxx.xxx.xxx
The current IP address
Mask
xxx.xxx.xxx.xxx
The current Subnet Mask address.
Gateway
xxx.xxx.xxx.xxx
The current Gateway address.
PrimDNS
xxx.xxx.xxx.xxx
The current Primary DNS address.
ScndDNS
xxx.xxx.xxx.xxx
The current Secondary DNS address.
Device
POLxxx_xxxxxx
The Host Name of the MTIII controller.
MAC
xx-xx-xx-xx-xx-xx
The MAC address of the MTIII controller.
In order to modify the MTIII IP Network configuration, do the following operations:
 access the Settings menu
 set the DHCP option to Off
 modify the IP, Mask, Gateway, PrimDNS and ScndDNS addresses, if needed, taking care of the current
network settings
 set Apply changes parameter to Yes to save the configuration and restart the MTIII controller.
The default internet configuration is:
Parameter
Default Value
IP
192.168.1.42
Mask
255.255.255.0