Daikin FTHF20RVLT - Pre-Operation Preparations; Battery Installation and Holder Mounting; Powering Up the Unit

9
English
Preparation before Operation
■
To set the batteries
1. Slide the back cover to take it off.
2. Set two dry batteries AAA.LR03 (alkaline).
3. Set the back cover as before.
■
1. Choose a place from where the signals can
reach the unit.
2. Fix the holder to a wall, a pillar, or similar
location with the scr
accessory set.
ews supplied with the
3. Place the remote controller in the remote
controller holder.
NOTE
■
Notes on batteries
■
Low batteries alert
• When replacing the batteries, use batteries of the same type, and replace both old batteries together.
• When
• To prevent remote controller from deteriorate batteries. When batteries seem to be dying (battery voltage lower).
The LCD will blink and the remote controller will stop all operations except to turn off the air conditioner.
To operate remote controller again, replace all the batteries with the new, size AAA. LR03 (Alkaline).
the system is not used for a long time, take the batteries off.
• The batteries will last for approx. 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs
within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
■
Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult the
shop if that is
the case.
• If
the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
To fix the remote controller holder on the wall
Position and
correctly!
2
3
1
Remote
controller
holder
Remote controller
Screws
■
Turn the breaker on
•
the re
After the power is turned on, the flaps of the indoor unit opens and closes once to set
ference position.