EasyManua.ls Logo

Daikin FTK24NMVJU - 1.2 Heat Pump

Daikin FTK24NMVJU
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
EnglishEnglish
Read Before Operation
Preparation Before Operation
To insert the batteries
1. Remove the back cover by sliding and then
slightly lifting it�
2. Insert 2 dry batteries AAA�LR03 (alkaline)�
3. Replace the back cover
To x the remote controller holder to a wall
1.
Choose a place where the signals reach the unit�
2.
Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the holder
3. Hang the remote controller on the remote
controller holder
Fahrenheit/Celsius display switch
Press and (TIMER button)
simultaneously for about 5 seconds�
•ThetemperaturewillbedisplayedinCelsiuswhenitispresentlydisplayedin
Fahrenheit,andviceversa.
•Theswitchoperationisonlypossiblewhenthetemperatureisbeingdisplayed.
Turn on the circuit breaker
•Afterthepoweristurnedon,theapoftheindoorunitopensandclosesoncetosetthe
referenceposition.
Position and
correctly!
2
3
1
Remote
controller holder
Remote controller
Screws
NOTE
Notes on batteries
•Whenreplacingthebatteries,usebatteriesofthesametype,andreplacebotholdbatteriestogether.
•Thebatterieswilllastforabout1year.Iftheremotecontrollerdisplaybeginstofadeandthepossibletransmissionrangebecomesshorterwithin
ayear,however,replacebothbatterieswithnew,sizeAAA.LR03(alkaline).
•Thebatteriessuppliedwiththeremotecontrollerareforinitialoperation.Thebatteriesmayrunoutinlessthan1year.
Note on remote controller
•Donotdroptheremotecontroller.Donotgetitwet.
Fahrenheit/Celsius display change function of remote controller
•ThesettemperaturemayincreasewhenthedisplayischangedtoCelsiusfromFahrenheit,becauseafractionof0.5°Cisroundedup.
•
Example:Asettemperatureof65°F(equivalentto18.5°C)willbeconvertedinto19°C.
WhenthedisplayischangedtoFahrenheitagain,thesettemperaturewillbeconvertedinto66°F(equivalentto19°C)insteadoftheoriginal
settemperature(65°F)butasettemperatureof66°F(equivalentto19°C)willbeconvertedinto19°Cwithnotemperaturechange.
•
AreceptionsoundwillgooffforthetransmissionofsettemperaturetotheindoorunitatthetimeofsettingtheFahrenheit/Celsiusdisplaychangefunction.
01_EN_3P379751-2A.indd 10 11/12/2014 6:18:35 PM

Other manuals for Daikin FTK24NMVJU

Related product manuals