Clean or replace the titanium
2.
apatite photocatalytic air-
purifying fi lter.
[Maintenance]
Vacuum dusts, and soak in 2-1
lukewarm water or water for about
10 to 15 minutes if dirt is heavy.
Do not remove the fi lter from frame when •
washing with water.
After washing, shake off remaining 2-2
water and dry in the shade.
Since the material is made out of polyester, do •
not wring out the fi lter when removing water from
it.
[Replacement]
Remove the tabs on the fi lter
frame and replace with a new
fi lter.
Do not throw away the fi lter frame. Reuse the •
fi lter frame when replacing the titanium apatite
photocatalytic air-purifying fi lter.
Dispose of the old fi lter as non-fl ammable waste.•
Set the fi lters as they were
3.
and close the front panel.
Press the front panel at both sides and the •
central area.
NOTE
Operation with dirty fi lters:•
cannot deodorize the air, –
cannot clean the air, –
results in poor heating or cooling, –
may cause odour. –
Dispose of old fi lters as non-fl ammable waste. •
To order titanium apatite photocatalytic air-purifying •
fi lter contact to the service shop there you bought the
air conditioner.
Item
Titanium apatite photocatalytic
air-purifying fi lter (without frame) 1 set
Part No. KAF970A46
Titanium apatite photocatalytic air-purifying fi lter
01_EN_3P291209-2.indd 33 12/8/2011 8:48:39 PM
To Next Page
Loading...
