Instruction SiENBE12-713
206 System Configuration
FILTERS
1. Open the front panel. (page 26.)
2. Remove the air filters.
• Press the claws on the right and left of the air
filter down slightly, then pull upward.
3. Take off the Titanium Apatite Photocatalytic
Air-Purifying Filter.
• Hold the tabs of the frame, and remove the
claws in 4 places.
4. Clean or replace each filter.
• See figure.
5. Set the air filter Titanium Apatite
Photocatalytic Air-Purifying Filter as they
were and close the front panel.
• Operation without air filters may result in
troubles as dust will accumulate inside the
indoor unit.
"
Air Filter
1. Wash the air filters with water or clean them
with vacuum cleaner.
• If the dust does not come off easily, wash
them with neutral detergent thinned with
lukewarm water, then dry them up in the
shade.
• It is recommended to clean the air filters
every two weeks.
"
Titanium Apatite Photocatalytic Air-Purifying Filter
The Titanium Apatite Photocatalytic Air-Purifying
Filter can be renewed by washing it with water once
every 6 months. We recommend replacing it once
every 3 years.
[Maintenance]
1. Vacuum dusts, and soak in warm water or water for about 10 to 15 minutes if dirt is heavy.
2. Do not remove filter from frame when washing with water.
3. After washing, shake off remaining water and dry in the shade.
4. Since the material is made out of paper, do not wring out the filter when removing
water from it.
[Replacement]
1. Remove the tabs on the filter frame and replace with a new filter.
• Dispose of the old filter as flammable waste.
Titanium Apatite
Photocatalytic
Air-Purifying
Filter
Air filter
To Next Page
Loading...
