Daikin FTKV25NVM4 User Manual

REMOVAL
PROCEDURE
SERVICE MANUAL
Indoor Unit
Inverter / Non-Inverter
Wall Mounted Type
2.0/2.5/3.5 kW Class
9000/13000 Btu/h Class
Si041251EC

Daikin FTKV25NVM4 Specifications

General

Brand	Daikin
Model	FTKV25NVM4
Category	Air Conditioner
Language	English

Summary

Air Filters

Remove Air Filters

Electrical Box Component Removal

Wire Fixture and Terminal Board Disconnection

Connector Disconnection

Thermistor and Ground Wire Detachment

Electrical Box Detachment

Printed Circuit Board (PCB) Removal

Shield Plate and Signal Receiver Unit Access

Steps to remove the shield plate and release the indoor heat exchanger thermistor.

Terminal Board and Signal Receiver Unit Removal

Procedures for removing the terminal board and the signal receiver unit.

Signal Receiver PCB and INTELLIGENT EYE Sensor PCB Removal

Steps to remove the signal receiver PCB and the INTELLIGENT EYE sensor PCB.

Display PCB and Control PCB Removal

Instructions for removing the display PCB and the control PCB.

Fan Motor Removal

Fan Motor Lead Wire and Plate Preparation

Fan Motor Detachment

Indoor Heat Exchanger Removal

Heat Exchanger Mounting Screw and Piping Disconnection

Steps to remove screws fixing the heat exchanger and disconnect the pipings.

Indoor Unit Installation Plate Detachment

Piping Fixture and Auxiliary Piping Handling

Steps to unfasten piping fixture hooks and adjust auxiliary piping.

Heat Exchanger Final Detachment

Steps to release upper/lower hooks and remove the indoor heat exchanger.

Fan Rotor Removal

Side Plate and Fan Rotor Screw Removal

Fan Motor Fixing Plate and Fan Motor Removal

Left Side Plate and Bearing Removal