20
CARE
Care and Cleaning
CAUTION
■
Indoor unit, Outdoor unit and Remote controller
1. Wipe them with dry soft cloth.
■
Top front panel
1. Open the top front panel.
• Open the top front panel by placing a finger on the
panel tab on either side of the top front panel.
2. Remove the top front panel.
•
With the top front panel open so that it is almost
horizontal, slide it to the right.
The revolving axis on the left will come off.
The revolving axis on the right can be removed by
sliding the top front panel to the left.
3. Clean the top front panel
•
Wipe it with a soft cloth soaked in water.
•
Only neutral detergent may be used.
•
In case of washing the top front panel with water, dry it
with cloth, dry it up in the shade after washing.
4. Attach the top front panel
•
Place the revolving axes on either side of the top
front panel into the holes and slowly close.
(Press either side of the top front panel.)
CAUTION
Units
•
Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
•
When removing or attaching the top front panel, use a robust and stable stool and watch your steps carefully.
•
When removing or attaching the top front panel, support the top front panel securely with hand to prevent it from falling.
•
For cleaning, do not use hot water above 40
°
C, benzine, gasoline, thinner, nor other volatile oils,
polishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the top front panel is securely fixed.
•
Before cleaning, be sure to stop the operation and turn the breaker OFF.
•
Always shut down the unit (and close the panel) before doing any work.
Opening the panel during operation may cause the panel to fall off.
01_EN_3P119312-2C.fm Page 20 Thursday, October 13, 2005 2:30 PM
To Next Page
Loading...
Need help?
General
