Why did my Daikin FTXG35CVMAS Air Conditioner stop suddenly but the operation lamp is on?
If your Daikin Air Conditioner stops suddenly but the OPERATION lamp is on, it may be due to a sudden large voltage fluctuation for system protection. The unit will automatically resume operation in about 3 minutes.
What to do if my Daikin FTXG35CVMAS indoor unit is leaking water?
If water leaks from the indoor unit of your Daikin Air Conditioner, turn the breaker OFF and call the service shop.
How to fix a Daikin FTXG35CVMAS Air Conditioner that won't turn on?
If your Daikin Air Conditioner is not operating and the OPERATION lamp is off, check if a breaker is turned OFF or a fuse is blown. Also, verify if there is a power failure, if batteries are set in the remote controller, or if the timer setting is correct.
Why is the cooling/heating effect poor on my Daikin Air Conditioner?
If your Daikin Air Conditioner isn't cooling or heating well, several factors could be the cause. Begin by checking if the air filters are clean. Ensure that nothing is blocking the air inlet or outlet of either the indoor or outdoor units. Verify that the temperature setting is appropriate for your needs, and that all windows and doors are properly closed. Confirm that the airflow rate and direction are correctly set. Lastly, check if the unit is set to INTELLIGENT EYE mode, as this mode might be affecting the cooling or heating performance.
What to do if my Daikin Air Conditioner stops suddenly and the operation lamp flashes?
If your Daikin Air Conditioner suddenly stops and the OPERATION lamp is flashing, try these steps: Begin by cleaning the air filters to remove any accumulated dust or debris. Make sure there are no obstructions blocking the unit. After addressing these issues, turn the breaker OFF, wait a moment, and then turn it back ON. Finally, attempt to operate the air conditioner again using the remote controller.
What to do if a button on my Daikin FTXG35CVMAS Air Conditioner remote is not working?
If a switch or a button on your Daikin Air Conditioner often fails to work properly, turn the breaker OFF and call the service shop.
What to do if my Daikin FTXG35CVMAS Air Conditioner does not operate and the operation lamp is off?
If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: First, see if a breaker has tripped or a fuse has blown. Next, verify that there isn't a power failure in your area. Ensure that the batteries in the remote controller are correctly installed and have power. Finally, double-check that the timer setting is correct and hasn't inadvertently turned the unit off.
What to do if Daikin Air Conditioner shows abnormal functioning during operation?
If your Daikin Air Conditioner is showing abnormal behavior during operation, turn the breaker OFF, wait a few seconds, and then turn it back ON. After doing this, try operating the air conditioner again using the remote controller to see if the issue has been resolved.
Why doesn't hot air flow out immediately from my Daikin FTXG35CVMAS Air Conditioner after starting heating?
If hot air doesn't flow out soon after starting the heating operation on your Daikin Air Conditioner, allow 1 to 4 minutes for the unit to begin heating.
How to get rid of bad smell from my Daikin Air Conditioner?
If the indoor unit of your Daikin Air Conditioner gives out an odor, it is recommended to have the indoor unit washed by a technician.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Heating Capacity | 4.0 kW |
| Power Supply | 220-240V, 50Hz |
| Weight (Indoor Unit) | 10 kg |
| Weight (Outdoor Unit) | 30 kg |
| Type | Split System |
| Seasonal Energy Efficiency Ratio (SEER) | 6.10 |
| COP | 4.00 |
| Energy Efficiency Ratio (Heating) | 4.00 |
| Refrigerant | R-32 |
| Indoor Noise Level | 20 dB(A) (Low) |
To Next Page
