Why does my Daikin FTXS09DVJU Air Conditioner stop suddenly and the OPERATION lamp is on?
For system protection, the air conditioner may stop operating due to a sudden large voltage fluctuation. It automatically resumes operation in about 3 minutes.
Why is the cooling or heating effect poor on my Daikin Air Conditioner?
Check the following: * Are the air filters clean? * Is anything blocking the air inlet or outlet of the indoor and outdoor units? * Is the temperature setting appropriate? * Are the windows and doors closed? * Are the airflow rate and the air direction set appropriately? * Is the unit set to the INTELLIGENT EYE mode?
Why does hot air not flow out soon after starting the heating operation on my Daikin FTXS09DVJU?
The air conditioner is warming up. You should wait for 1 to 4 minutes.
Why does mist come out of the indoor unit of my Daikin FTXS09DVJU?
This happens when the air in the room is cooled into mist by the cold airflow during cooling operation.
Why does my Daikin FTXS09DVJU operation not start quickly?
This can occur when the ON/OFF button was pressed soon after operation was stopped, or when the mode was reselected. You should wait for about 3 minutes.
Why does the outdoor unit of my Daikin FTXS09DVJU emit water or steam?
In HEAT mode, the frost on the outdoor unit melts into water or steam when the air conditioner is in defrost operation. In COOL or DRY mode, moisture in the air condenses into water on the cool surface of outdoor unit piping and drips.
Why does the indoor unit of my Daikin FTXS09DVJU give out odor?
This happens when smells from the room, furniture, or cigarettes are absorbed into the unit and discharged with the airflow. We recommend you have the indoor unit washed by a technician. Consult your authorized dealer where you bought the air conditioner.
What to do if my Daikin FTXS09DVJU Air Conditioner doesn't operate and the OPERATION lamp is off?
Check if a breaker has been turned OFF, or a fuse has blown. Also, verify if there is a power failure, if fresh batteries are installed in the remote controller, and if the timer setting is correct.
What to do if the Daikin Air Conditioner operation stops suddenly and the OPERATION lamp flashes?
Check if the air filters are clean and if anything is blocking the air inlet or outlet of the indoor and outdoor units. Turn the electrical breaker off, clean the air filters or remove any obstacles from the inlet and outlet. Then, turn the breaker back on and try operating the air conditioner with the remote controller.
What to do if an abnormal functioning happens during operation of my Daikin FTXS09DVJU?
The air conditioner may malfunction due to lightning or radio waves. To reset it, turn the circuit breaker OFF, then turn it back ON and try operating the air conditioner with the remote controller.
General| Brand | Daikin |
|---|---|
| Model | FTXS09DVJU |
| Category | Air Conditioner |
| Language | English |
Identifies components of the indoor air conditioning unit.
Identifies components of the outdoor air conditioning unit.
Instructions for inserting batteries into the remote controller.
Guidance on remote operation, range, and holder mounting.
Procedures for setting the clock and turning on the breaker.
Steps to initiate and terminate air conditioner operation.
How to choose between AUTO, DRY, COOL, HEAT, and FAN modes.
How to adjust the desired temperature and fan speed.
How to adjust horizontal and vertical louvers for airflow direction.
Maximizes cooling/heating effect for a limited time.
Lowers outdoor unit noise level for quiet operation.
Records and recalls preferred temperature and airflow settings.
Uses a sensor to detect human movement for energy saving.
Setting the timer to turn the unit off automatically.
Setting the timer to turn the unit on automatically.
How to set both ON and OFF timers simultaneously.
Instructions for cleaning the indoor unit, outdoor unit, and remote.
Procedures for cleaning and replacing air filters.
Essential checks before operating or storing the unit.
Diagnosing and resolving typical operational problems.
Re-verify issues, contact dealer, and disposal requirements.
Interpreting error codes displayed on the remote controller.
To Next Page
