■English 13
■
To adjust the vertical blades (louvers)
Hold the knob and move the louvers.
(You will find a knob on the left-side and the right-side blades.)
Notes on flaps and louvers angles
• When “ SWING button ” is selected, the
flaps swinging range depends on the
operation mode. (See the figure.)
■ ATTENTION
• Always use a remote controller to adjust the
flaps angle. If you attempt to move it forcibly
with hand when it is swinging, the
mechanism may be broken.
• Be careful when adjusting the louvers.
Inside the air outlet, a fan is rotating at a
high speed and may cause bodily injury if
fan comes in contact with fingers.
In DRY mode or COOL mode
In HEAT or FAN mode
When stop operation
Upper limit in cooling
Lower limit in cooling
0°
25°
5°
30°
When stop operation
Upper limit in heating
Lower limit in heating
01_EN_3P141693-1K.fm Page 13 Tuesday, September 19, 2006 3:46 PM
To Next Page
Loading...
