INTELLIGENT EYE Operation
To adjust the angle of the INTELLIGENT EYE sensor
• You can adjust the angle of the INTELLIGENT EYE
sensor to increase the detection area.
(Adjustable angle: 15° to right and left of centre)
• Gently push and slide the sensor to adjust the angle.
After adjusting the angle, wipe the sensor gently with •
a clean cloth, being careful not to scratch the sensor.
“INTELLIGENT EYE” is useful for Energy Saving
Energy saving operation
Change the temperature –3.6°F (–2°C) in HEAT / +3.6°F (+2°C) in COOL / +1.8°F (+1°C) in dry mode from set temperature.•
Decrease the airfl ow rate slightly in FAN mode only.•
If no presence detected in the room for 20 minutes.•
NOTE
Notes on “INTELLIGENT EYE”
Application range is as follows.•
80°
50°
16ft
(5m)
50°
16ft (5m)
Vertical angle 80°
(Side View)
Horizontal angle 100°
(Top View)
Sensor may not detect moving objects further than 16ft (5m) away. (Check the application range)•
Sensor detection sensitivity changes according to indoor unit location, the speed of passersby, temperature range, etc.•
The sensor also mistakenly detects pets, sunlight, fl uttering curtains and light refl ected off of mirrors as passersby.•
INTELLIGENT EYE operatipon will not go on during powerful operation.•
NIGHT SET MODE •
Page 19
will not go on during use of INTELLIGENT EYE operation.
CAUTION
Do not place large objects near the sensor.•
Also keep heating units or humidifi ers outside the sensor’s detection area. This sensor can detect undesirable objects.
Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
•
INTELLIGENT EYE
sensor
15°15°
Moving the sensor to the left Moving the sensor to the right
01_EN_3P232717-1C.indd 1401_EN_3P232717-1C.indd 14 12/22/2008 2:51:34 PM12/22/2008 2:51:34 PM
To Next Page
Loading...
