TIMER Operation
To use ON TIMER operation
Check that the clock is correct.•
If not, set the clock to the present time.
Page 9
Press 1. .
” is displayed.
” blinks.
“
“
Press 2. until the time setting reaches the point
you like.
Every pressing of either button increases or decreases the time setting by 10 minutes. Holding •
down either button changes the setting rapidly.
Press 3. again.
The TIMER lamp lights up.•
To cancel ON TIMER Operation
Press .
The TIMER lamp goes off.•
To combine ON TIMER and OFF TIMER
A sample setting for combining the two timers is shown below.•
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
ATTENTION
In the following cases, set the timer again.
After a breaker has turned OFF.•
After a power failure.•
After replacing batteries in the remote controller.•
01_EN_3P232717-1C.indd 2001_EN_3P232717-1C.indd 20 12/22/2008 2:51:37 PM12/22/2008 2:51:37 PM