SiENBE12-713 Instruction
System Configuration 165
FILTERS
1. Open the front panel.
2. Pull out the air filters.
• Push a little upwards the tab at the
center of each air filter, then pull it down.
3. Take off the air purifying filter with
photocatalytic deodorizing function.
• Press the top of the air-cleaning filter
onto the tabs (3 tabs at top). Then press
the bottom of the filter up slightly, and
press it onto the tabs (3 at bottom).
4. Clean or replace each filter.
See figure.
5. Set the air filter and the Titanium Apatite
Photocatalytic Air-Purifying Filter as they
were and close the front panel.
• Press the front panel at both sides and
the center.
"
Air Filter
1. Wash the air filters with water or clean
them with vacuum cleaner.
• If the dust does not come off easily,
wash them with neutral detergent
thinned with lukewarm water, then dry
them up in the shade.
• It is recommended to clean the air filters
every two weeks.
"
Titanium Apatite Photocatalytic Air-purifying Filter
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed by washing it with water once
every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
1. Remove dust with a vacuum cleaner and wash lightly with water.
2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning
agent.
3. After washing, shake off remaining water and dry in the shade.
4. Since the material is made out of paper, do not wring out the filter when removing
water from it.
[Replacement]
1. Remove the tabs on the filter frame and replace with a new filter.
• Dispose of the old filter as flammable waste.
tabs (3 tabs at top)
tabs (3 at bottom)
To Next Page
Loading...
