34
1. Take off the titanium
apatite photocatalytic air-
purifying lter.
• Open the front panel and pull out the air lters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
Claw
2.
Clean or replace the titanium
apatite photocatalytic air-
purifying lter.
[Maintenance]
2-1 Vacuum dusts, and soak in cold or
lukewarm water (avoid using warm
or hot water) for about 10 to
15 minutes if dirt is heavy.
• Do not remove the lter from frame when
washing with water.
2-2 After washing, shake off remaining
water and dry in the shade.
• Since the material is made out of polyester, do
not wring out the lter when removing water
from it.
[Replacement]
Remove the lter from the
lter frame and attach a
new one.
• Do not throw away the lter frame. Reuse the
lter frame when replacing the titanium apatite
photocatalytic air-purifying lter.
• Dispose of the old lter as non-ammable waste.
3. Set the lters as they were
and close the front panel.
• Press the front panel at both sides and the
center.
NOTE
• Operation with dirty lters:
– cannot deodorize the air,
– cannot clean the air,
– results in poor heating or cooling,
– may cause odour.
• Dispose of old lters as non-ammable waste.
• To order titanium apatite photocatalytic air-purifying
lter contact to the service shop there you bought the
air conditioner.
Item
Titanium apatite photocatalytic
air-purifying lter (without frame) 1 set
Part No. KAF970A46
■
Titanium apatite photocatalytic air-purifying lter
To Next Page
Loading...
