To use ON TIMER operation
Check that the clock is correct.•
If not, set the clock to the present time.
Page 9
Press1. .
” is displayed.
” blinks.
“
“
“ • ” and day of the week are no longer displayed on the LCD.
Press2. until the time setting reaches the point
you like.
Each pressing of either button increases or decreases the time setting by 10 minutes. •
Holding down either button changes the time setting rapidly.
Press3. again.
“ • ” and setting time are displayed on the LCD.
The TIMER lamp lights yellow.•
Display
To cancel ON TIMER operation
Press .
“ • ” and setting time are no longer displayed on the LCD.
“ •
” and day of the week are displayed on the LCD.
The TIMER lamp goes off.•
To combine ON TIMER and OFF TIMER
A sample setting for combining the 2 timers is shown below.•
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
In the following cases, set the timer again.
After a breaker has turned off.•
After a power failure.•
After replacing batteries in the remote controller.•
To Next Page
Loading...
