English
36
Care and Cleaning
■
Titanium apatite deodorizing fi lter
1. Open the front panel and
pull out the air fi lters.
Page 32
2. Take off the Titanium
apatite deodorizing fi lter.
• Remove the fi lters from the tabs.
ClawClaw
3. Clean or replace the
Titanium apatite
deodorizing fi lter.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the fi lter to remove water from it.
[Replacement]
Remove the fi lter from the tabs
and prepare a new one.
• Dispose of the old fi lter as non-fl ammable waste.
4. Insert the Titanium apatite
deodorizing fi lter as they
were.
• When attaching the fi lter, check that the fi lter is
properly set in the tabs.
5. Reattach the fi lters.
Page 34
6. Close the front panel
slowly.
Page 34
NOTE
• Operation with dirty fi lters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old fi lters as non-fl ammable waste.
• To order a Titanium apatite deodorizing fi lter, contact the dealer
where you bought the unit.
FTXTM40M2V1B
To Next Page
Loading...
