14
2 After operation stops, turn off the
breaker for the room air conditioner.
3 Clean the air filters and set them
again.
4 Take out batteries from the remote
controller.
CAUTION
Clean the front grille.
●
You may wipe it with a soft cloth soaked in water.
●
Only neutral detergent may be used.
●
You may wash the grille with water. After washing,
dry it with cloth, then dry it up in the shade.
Remove the front grille.
●
Supporting the front grille with one hand, release
the lock by sliding down the knob with the other
hand.
●
To remove the front grille, pull it toward yourself
with both hands.
Care and Cleaning
Cleaning the front grille
You may remove the front grille for cleaning.
●
When removing or attaching the front grille, use a
robust and stable stool and watch your steps carefully.
●
When removing or attaching the front grille, support the
grille securely with hand to prevent it from falling.
●
For cleaning, do not use water hotter than 40°C, benzine,
gasoline, thinner, nor other volatile oils, polishing compound,
scrubbing brushes nor other hard stuff.
●
After cleaning, make sure that the front grille is securely
fixed.
1
3
2
4
Attach the front grille.
●
Set the 3 keys of the front grille into the slots and
push them in all the way.
●
Supporting the front grille with one hand, fit the
lock by sliding up the knob with the other hand.
●
Close the front grille slowly in this state. (Push
the grille at the 3 points, two at both sides and in
the middle.)
Open the front grille.
● Hold the grille by the tabs on the two sides
and lift it until it stops with a click.
Before a long idle period
1
2
Press and select “ ”.
Press .
1 Operate the fan alone for several
hours on a fine day to dry out the in-
side.
<FT>
Check that the base, stand and other
fittings of the outdoor unit are not
decayed or corroded.
Check that nothing blocks the air inlets
and the outlets of the indoor unit and
the outdoor unit.
Check that the drain comes smoothly
out of the drain hose during COOL or
DRY operation.
● If no drain water is seen, water may be
leaking from the indoor unit. Stop
operation and consult the service shop if
this is the case.
Check
Fit the key
into the slot.
Slide up the knob.
<FTY>
1
2
Press and select “ ”.
Press
and set the
temperature to 32°C
3
Press .
• Perform this operation when the room
temperature is under 28°C.
To Next Page
Loading...
